|Jan 19, 2013, 08:53 PM|
Quaternium Tricoptex Tricopter Build Log
Quaternium Tricoptex Tricopter frame from Spain. This is an unboxing and component overview of a new Tricopter build.
I'll be running the following equipment
Crius All in One Pro Flight Controller v1.1 - running MPNG 2.9rc5
Crius CN-06 GPS
MinimOSD v.1 board - Running MinimOSD-extra Firmware
RCtimer bluetooth Module
NTM 2826 1200kv motors
RCTimer 8x4 Carbon Fiber props
HobbyKing Blue series 30A ESC - Flashed with SimonK BS-NFet firmware
Turnigy TGY 113MG servo for the Yaw
ReadyMadeRC RMRC-480N CCD camera
Fatshark 250mw Video Transmitter
Fatshark Attitude SD goggles with homemade cloverleafs
Turnigy Nanotech 3300mah 35-70c battery
Custom power distribution board
Custom wiring harnesses
* Overview and Planning
|Jul 04, 2013, 02:34 PM|
Dump that Crius AIO and use the APM 2.5.
APM 2.5 with the recent firmware release 3.0 out performs any the flight control boards currently in the market. It's far superior over the DJI Naza in every aspect for the fraction of the cost.
APM 2.5 all the way, Baby!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Build Log||My Tricopter build log||fpv-tor||Multirotor Talk||27||Jul 04, 2013 02:40 PM|
|Build Log||FPV/UAV/AP tricopter build log [Changed from "Got the stuff... I went all out"]||slisgrinder||FPV Talk||47||Jul 25, 2011 09:57 AM|