Espritmodel.com Telemetry Radio
Closed Thread
Thread Tools
This thread is privately moderated by GVMech, who may elect to delete unwanted replies.
Old Dec 31, 2012, 10:55 AM
Gulfstream Mech
GVMech's Avatar
Marlton NJ
Joined Jun 2005
29 Posts
Trader Rating: 30
Sold
DN Power Li-ion/Li-Polymer Micro Controlled Balance charger

For Sale Still In good working condition. Great Price. 40.00 Shipped

DN Power Micro-Controlled LiPo/Li-ion Balance Charger w/ LCD Display
It has the Wall Charger and Banna Clips for charging on the car battery.
Specifications:

1. Input voltage: DC 11V~15V. The working electric current is less than 6A when it is charged in full load. The current of the fuse is 10A which could prevent short circuit. Note: Make sure the input voltage is not higher than 15V, especially when you use a DC adaptor, please measure the voltage before connect it to the charger, chargers damaged due to high input voltage are not covered by warranty.
2. The charge current is 0.2A~2.0A and the adjusting step is 0.2A which can be set by the buttons on the board.
3. Controlled by 4 separated internal micro computers. charge 1S-4S battery separately. no like other serial charging + balancer setup on the market. More efficient.
4. 4 separated JST style charging ports, one general charging port.
5. Big LCD display. real-time displays voltage and charging processing clearly and separately.
6. Low voltage protection. charger won't charge any cell if voltage is lower than 2.7v.
7. Automatically stop charging when it's done. A buzzer will call.
8. 4 separated parallel charging circuits ensure your battery 100% fully charged. Higher efficiency.
9. Charge mode of the balanced parallel connection
A. charge in parallel connection for one single cell or four single cells at one time
B. charge in parallel connection for a pile of two series-wound lithium cells or two piles of two series-wound lithium cells at one time
C. charge in parallel connection for a pile of three series-wound lithium cells or one single lithium cell at one time
D. charge in parallel connection for a pile of four series-wound lithium cells
10. Working rating: -20 ~ 60C
11. Fully circuit protection: protect the charger and battery even when connect the battery or the power supply reversely.
12. General charging port will allow you charge any lipo battery which has balanering leads.
GVMech is offline Find More Posts by GVMech
Last edited by GVMech; Dec 31, 2012 at 04:45 PM.
Sign up now
to remove ads between posts
Old Jan 02, 2013, 03:46 PM
Registered User
Joined Dec 2012
1 Posts
Trader Rating: 1
PM sent.
jdwilcox is offline Find More Posts by jdwilcox
Old Jan 03, 2013, 07:50 PM
Gulfstream Mech
GVMech's Avatar
Marlton NJ
Joined Jun 2005
29 Posts
Trader Rating: 30
Sold
GVMech is offline Find More Posts by GVMech
Closed Thread

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
New Product Introduce: DN Power Micro-Controlled LiPo/Li-Lon Balance Charger w/ LCD Display ildo Batteries and Chargers 935 Feb 03, 2013 11:05 AM
Sold DN Power Li-Polymer/Li-ion 1S - 4S Balance Charger racin06 Aircraft - Electric - Batteries & Chargers (FS/W) 2 Jul 30, 2009 05:57 PM
Off Site DN Power G3 charger 1-6S Li-polymer / Li-ion supi7 Aircraft - Electric - Batteries & Chargers (FS/W) 0 Feb 15, 2009 10:32 AM
Sold Intro Sale: DN Power Micro-Controlled LiPo/Li-Lon Balance Charger w/ LCD Display ildo Aircraft - Electric - Batteries & Chargers (FS/W) 36 Jul 09, 2006 09:25 PM