|Dec 15, 2003, 10:59 PM|
Started as Trident 3D
I built this over the weekend, starting with the Trident plans.
PJS 300 motor
Jeti 06 speed control
2 Kokam 340 Lipoly
AUW 173 gm. (6 oz.)
Picture of side --
|Feb 02, 2004, 07:19 PM|
Nice job Jordan. Did you fly it yet? How about coming out to the dome in Bensenville? We've been there almost every Saturday night...
|Feb 02, 2004, 10:12 PM|
The plane flies very well, I would say almost pattern like. The rudder is very powerful and with the PJS300 I can climb out of a hover easily (I need to 'cause I don't hover very well). The fuselage is beat up now, I have never crashed it but I have run the batteries to cut off too many times and it doesn't glide well at all without power, so those landings are more arrivals. I have been flying on Thursday at the Bensenville dome. I just don't like the big crowd on Saturday. I saw Eric this last Thursday at the dome and got to fly his new foamy modeled after the Gee Bee. Flies nice very stable in hover and harrier position. I actually could hover it under control for maybe ten seconds at a time (that is by far my best). How are you and Mitch?
|Feb 03, 2004, 08:19 PM|
Mitch & I are good. We've been flying at the dome with Eric. Went this past Friday & Saturday. Eric made me up one of his foamies too, there were 4 of us flying in & out of each other. Really cool. Stop out on a Saturday night... (we see Rich from time to time)
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Looking for Trident 3D plans...||WreckRman2||Foamies (Kits)||2||Sep 24, 2004 10:20 AM|
|Trident 3D, 20% larger...||WreckRman2||Foamies (Kits)||0||Dec 17, 2003 02:11 AM|
|Trident 3D, PDF Plans?||WreckRman2||Foamies (Kits)||2||Dec 14, 2003 11:14 PM|
|And to think this started as a block of foam…||spreslar||Slope||35||Jan 14, 2003 04:07 PM|