SMALL - espritmodel.com SMALL - Telemetry SMALL - Radio
Reply
Thread Tools
This thread is privately moderated by jjmelo, who may elect to delete unwanted replies.
Old Dec 04, 2012, 07:18 PM
Registered User
jjmelo's Avatar
United States, CA, Burbank
Joined Aug 2012
445 Posts
Whoops!
BAE Hawk – Maiden flight + crash video

70mm BAE Hawk - Maiden Flight and crash (1 min 22 sec)


This is the maiden flight video and eventual crash and demise of this beautiful plane. The damage isn’t too bad, just a shattered canopy and a busted nose section. I ordered a new canopy, and I’ll start fixing the nose this week. Hopefully flight #2 will go better.

The center of gravity should’ve been set at 85mm behind the leading edge per the instruction manual, but the seller said it was wrong and it should’ve been set to 65mm. The manual for the E-Flite version of this plane says 80 – 90mm.

I balanced it at 65mm from the leading edge, after stuffing a 1000mah 3-cell in the nose to balance the plane, but after I crashed it, the very experienced fellow rc-enthusiast that was helping me out with the initial flight told me that it looked too tail-heavy.

It seemed like I had too much throw on the ailerons, even though I lowered the throw to 70% with 35% expo, per said gentleman’s recommendation.

http://www.flitereport.com/bae-hawk-...t-crash-video/
jjmelo is offline Find More Posts by jjmelo
RCG Plus Member
Last edited by jjmelo; Dec 04, 2012 at 07:23 PM.
Reply With Quote
Sign up now
to remove ads between posts
Reply

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion 70mm BAE Hawk maiden flight and crash. What happened? jjmelo Electric Ducted Fan Jet Talk 22 Oct 25, 2012 07:42 PM
Discussion BAE Hawk - 70mm EDF Maiden flight jjmelo Electric Ducted Fan Jet Talk 1 Oct 24, 2012 05:04 PM
For Sale NIB BAE E-Flight BAE Hawk (price lowered) dmize Aircraft - Electric - Jets (FS/W) 8 May 10, 2012 08:44 AM
Discussion AXI Powered UltraFly BAE Hawk Maiden Flight Report jimsky Pusher Prop Jet Models 9 Sep 19, 2006 06:48 PM