|Nov 20, 2012, 04:55 AM|
United States, HI, Kailua-Kona
Joined Mar 2012
New 50cc Yak. anyone know how I can get rid of my radio interferance???
Just got my first gasser. It's one from a guy in the club he flew it 3 times fine. I get it set up and running and I can't seem to stop the interferance to my servos. It's a hangar 9 Yak-54, got all Hi-Tec 625mg, 50cc Fuji engine electronic ign. I twisted all the servo wires, even ran shielded twisted extensions. NO LUCK and it gets worse as soon as the engine gets warmed up. I managed to get one flight in before I noticed how bad it was as the temp came up. Im an electric 3d pilot so im kinda stumpped. It didn't do it with the wings disconnected and ground run perfect. Im very frustrated I am dying to burn some fuel and make some noise.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||anyone know where i can get brushed motors?||derpron||Electric Plane Talk||16||Oct 09, 2012 04:31 AM|
|Discussion||Anyone know where I can get this colour (or close to it) of orange?||T.D.||Composites Fabrication||3||Oct 03, 2012 08:30 PM|
|Help!||How will i know when i'm getting close to my video systems range?||nogas||FPV Talk||29||Jul 28, 2012 04:04 AM|
|Discussion||I need some E clips for my axi 2814/22's... anyone know where to get em?||elliott000||Multirotor Talk||1||Jul 27, 2012 06:24 PM|
|Question||Anyone know where I can get a body for my F150 Raptor?||aarondn||Electric Power Cars||4||Mar 18, 2012 08:12 AM|