HobbyKing.com New Products Flash Sale
Thread Tools
Old Nov 18, 2012, 10:43 PM
Registered User
Canada, BC, Squamish
Joined Jul 2009
15 Posts
Can't acess program mode for ESC


I have just replaced the ESC in my Blade 300X heli with a E-flite 30 amp Pro that I have used previously in another heli.

As I recall I have been able to program this ESC in the past but now cannot get into program mode. The ESC works fine, and I only want to go through the program steps to confirm settings, etc. specifically soft start. I have followed the directions to the letter, tried increasing throttle end points, played with throttle trim, etc. to confirm that the ESC is seeing full throttle, which is what it needs to access program mode. I have been using LiPos at storage, rather than full, charge, and wonder if that would make any diffrence. Any other ideas?

Thanks for any replies.
Guil is offline Find More Posts by Guil
Reply With Quote
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! rctimer SK-20A esc can't enter calibration mode emuer Multirotor Electronics 5 Nov 18, 2012 01:26 AM
Help! Can't program Suppro 18A ESC , stuck ! fltekdiver Power Systems 1 Feb 24, 2012 07:03 PM
Discussion Eflite ESC, can't get into programming mode? rperego Power Systems 1 Feb 17, 2008 12:47 PM
Discussion Eflite ESC, can't get into programming mode? rperego Beginner Training Area (Aircraft-Electric) 1 Feb 17, 2008 12:46 PM
Can't enter programming mode on a new Phoenix-25 ESC Foam Crazy Castle Creations 9 Aug 12, 2005 11:57 PM