well, almost. i forgot something when i had it printed, so its missing one end

but its a start. the clips seem fragile, but work okay. i will need to reinforce them next time. the notches needed to be trimmed for length as well as height. the cap was fitting a little too loose. its made to use a thick grease to seal it.

Oh boy. I've been trying to use clips for over a year now. I make things outside of RC, two of which are an iPhone (in Otterbox) bike mount and a power box for lights on my longboard. The clips always break.

I hope the smaller scale works in your favor.

probly wont. then seem weak as it ism but it onyl has to work a hand ful of times. WTCs dont seem to get much maintinence on the inside. how often do you open up the fuse?

i guess time will tell.

Why clips just use 3m tape seal n dont look back =)

tape is.... a lot of variables. lots of places for it to go wrong. and 3m tape under water?

at any rate, im still playing with it. trying to find out what works and what dont.

(really, 3m makes a tape rated for submerged, not just water resistant???? would love to see that one! link? )