|Oct 23, 2012, 01:57 PM|
United States, AZ, Tucson
Joined Mar 2008
DJI F450 NAZA/GPS will not connect to assistant software, any ideas would be great.
I have been very busy with work and moving and have not powered up my F450 in over 3 months and have been absent from RC Groups.
I had a few minutes last night after unpacking all my RC stuff.
I did a quick hover in the house and it seemed ok but I forgot my switch placement for ATTI/MANUAL/GPS and IOC.
I plugged it into the computer to remind me the switch positions but it wouldn't connect with the assistant software. I've never had a problem before and I probably had one of the better flying quads out there and had absolutely zero issues after with everyone's help.
I did notice on DJI's website an update to 2.02 on the firmware and 1.8 on the assistant.
I didn't look to see what firmware I had but the assistant is 1.6. But should it have connected regardless right ?
Any ideas would be really great, I might finally get some time in the next few weeks to do some FPV again.
Also, has there been any revelations in the last three months that I should be aware of ?
|Oct 24, 2012, 06:53 PM|
If your on the old version... You'll need to remove your assistant and download the whole new platform and re-boot that Naza.
Give that a shot
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||DJI Naza Assistant software wont run||Andjons||Multirotor Talk||10||Aug 15, 2013 08:18 AM|
|Discussion||DJI Naza - DJI F450 or XAircraft X650?||totality||Multirotor Talk||14||Jun 25, 2012 02:59 AM|
|Discussion||DJI F450 NAZA kit vs Witespy VC450 with NAZA kit||MC21||Multirotor Talk||5||May 16, 2012 03:16 PM|
|Sold||DJI Naza and F450 - BNF||flymustangs||Aircraft - Electric - Multirotor (FS/W)||4||Feb 21, 2012 12:36 AM|
|Found||Dji f450 + naza||h00t||Aircraft - Electric - Multirotor (FS/W)||1||Feb 12, 2012 10:33 AM|