HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Oct 02, 2012, 12:11 PM
Build more, websurf less
FlyingW's Avatar
Long Valley, NJ, USA
Joined Dec 2001
1,705 Posts
Question
Advice on working with XDP

I needed to run the XDP program to change the channel mapping on some nano receivers. I had a perceived problem where I thought the XDP program could not see the XDP device.

I have Windows 7. Installed the latest program from XPS (as Administrator) and the drivers installed successfully. Even tried a new usb cable.

Turns out the XDP program was looking for the actual receiver - not the XDP device! It works just fine.

I felt a little foolish, but was relieved to be able to make progress on the project.

Paul
FlyingW is offline Find More Posts by FlyingW
Last edited by FlyingW; Oct 03, 2012 at 07:54 AM. Reason: continuing education
Reply With Quote
Sign up now
to remove ads between posts
Old Oct 02, 2012, 02:31 PM
Build more, websurf less
FlyingW's Avatar
Long Valley, NJ, USA
Joined Dec 2001
1,705 Posts
Got it working as described above.
FlyingW is offline Find More Posts by FlyingW
Last edited by FlyingW; Oct 03, 2012 at 07:54 AM.
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Help. Cannot get started with Flamewheel and DJI alan2 Multirotor Electronics 8 Sep 05, 2012 06:52 PM
Discussion APM2.0 AUTO RETURN HOME SUCCESS! But cannot get position hold. OPEN MY PIDs. votreami Multirotor Talk 2 Jun 08, 2012 06:04 AM
Help! Cannot get gyro to hold the tail radarman Large Electric Helis 0 May 05, 2012 02:37 PM
Discussion Cannot get 12v DC output from Delta DPS-700EB brightfan Batteries and Chargers 5 Apr 01, 2012 12:06 AM
Sold xtremelink device programmer (xdp) 4*60 Aircraft - General - Radio Equipment (FS/W) 2 Apr 18, 2010 02:01 PM