SMALL - espritmodel.com SMALL - Telemetry SMALL - Radio
Reply
Thread Tools
Old Sep 17, 2012, 05:27 PM
Castle Support
Clintstone's Avatar
USA, GA, Statesboro
Joined Oct 2007
966 Posts
Mini-HowTo
Basic Instructions for Castle VBAR external GOV Support

The attachment should be easy to follow... It is not meant to replace the VBAR instructions by any means but rather this can be used to apply the Castle ESC to the VBAR setup with the use of Castles new Firmware...4.02 and Newer Castle FIrmware. The Edge ESC can be set to External GOV mode and the White Auxiliary wire can be activated to RPM Out and the White wire can be plugged into the Signal side of the port where the RPM sensor would normally plug in... The voltage is 3.3v so this will work with the Mini Vbar and the full Size.
Clintstone is offline Find More Posts by Clintstone
Last edited by Clintstone; Sep 29, 2014 at 01:28 PM.
Reply With Quote
Sign up now
to remove ads between posts
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Mac support for Castle Creations products! CrazyJB Castle Creations 36 Sep 01, 2013 03:58 PM
Discussion Castle Gov Mode mikes68charger Beginner Training Area (Heli-Electric) 3 Jan 17, 2013 09:33 PM
Sold [SOLD] - Castle Ice 100 + RPM Sensor for vBar + Castle Link Wynn1427 Aircraft - Electric - Power Systems (FS/W) 3 Jun 28, 2012 10:18 AM
Discussion Firmware Patch to support vBar Gov? OnTheSnap Castle Creations 218 Jan 30, 2012 04:37 PM
Discussion Words, phrases and Lies. Trickery used by Gov. to Bolster Support for wars. BACKEMFNRG Life, The Universe, and Politics 32 Jul 03, 2007 07:34 PM