 |
 |
|
 |
 |
|
|
|
|
| Thread Tools |
| This thread is privately moderated by RHTizzy, who may elect to delete unwanted replies. |
Aug 28, 2012, 02:38 PM
|
|
The Netherlands, NH, Bussum
Joined Feb 2012
207 Posts
|
Bluetooth on the Crius AIOP
Bluetooth Module must have a Baud of 115200bps to connect
Bluetooth should connect to FTDI port (Tx/Rx3) (5v-5v, GND-GND, TX-RX, RX-TX) When you want to send a new firmware you must unplug the BT to connect USB for uploading it. MPNG - set appropriate port speed in APM_Config.h 
|
|
Last edited by RHTizzy; Jan 08, 2013 at 11:54 AM.
|
|
| |
|
|
|
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Discussion Crius MultiWii AIO boards | Katch | Multirotor Electronics | 3862 | Yesterday 07:15 PM |
| Discussion What is the max number of AUX channels you can use on a Crius Multiwii SE? | signal15 | Multirotor Electronics | 7 | Apr 04, 2013 04:56 AM |
| Sold MWC Crius Flight Controller with FTDI, Bluetooth and LCD | WhiteFox50 | Aircraft - Electric - Multirotor (FS/W) | 1 | Aug 17, 2012 10:24 AM |
| Scratch built boat not criusing smooth. | Vince003 | Racing Boats - Electric | 10 | Jul 16, 2004 01:58 PM |
|
|