|Nov 22, 2003, 03:00 AM|
Re: Does any one know the gear ratio on falcon 46 SE V2
"Greg" <firstname.lastname@example.org> wrote in message
> Does any one know the gear ratio on falcon 46 SE V2
> I am setting up my GV-1
Not off-hand Greg, but it's easy to find out. Use something to mark the
clutch bell, then rotate the main blades backwards for one full revolution
and count the number of turns the clutch bell makes. There's your ratio.
Please note my E-mail address is "beavis dot original at ntlworld dot com"
(with the obvious changes)
Beavisland now lives at
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||does any one know where i can find this chip?||Myles Eynon||Scratchbuilt Indoor and Micro Models||3||Apr 13, 2005 02:38 PM|
|does any one know what the weight ofthe greatplane u can do 3d wing?||cappilot||3D Flying||2||Jan 16, 2005 11:12 AM|
|Does any one know where I can buy an inexpensive hot wire knife/saw?||flyboy1987||Foamies (Kits)||3||Apr 26, 2004 08:14 AM|
|Does any one know how to tile a plan in adobe?||Funflier1||The Builders Workshop||5||Feb 01, 2004 04:07 AM|