HobbyKing.com New Products Flash Sale
Reply
Thread Tools
This thread is privately moderated by Jack Crossfire, who may elect to delete unwanted replies.
Old Aug 08, 2012, 10:11 PM
Registered User
Jack Crossfire's Avatar
Calif*
Joined Sep 2006
2,140 Posts
Discussion
Fabrication day

Sonar came out at 6g when miniaturized. A tri-state op-amp would still be a lot better. The h-bridge is a buster to solder & a real nail biter during the 1st 30V power up.

The ferrite inductor is a weight buster. Getting 30V takes either lots of ferrite or lots of ceramic. Any 6x voltage increase requires storing a lot of charge. Connecting it to the CPU requires the actual aircraft, to route the cables.


After spending a good 8 hours fabricating without even getting to the camera, the massive complexity of the electronics & boredom required to do this simple thing became obvious. The complete electronics would come to 12 hours, not counting airframe assembly.
Jack Crossfire is offline Find More Posts by Jack Crossfire
RCG Plus Member
Last edited by Jack Crossfire; Aug 09, 2012 at 12:40 AM.
Reply With Quote
Sign up now
to remove ads between posts
Reply

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Good fabric look covering for smaller planes? bdshort The Builders Workshop 30 Jul 26, 2012 10:29 PM
Discussion Funky fabric samc99us Composites Fabrication 10 Jul 18, 2012 08:21 AM
Found Great Planes Cub Solartex Fabric goldwinger Aircraft - General - Miscellaneous (FS/W) 3 Jul 16, 2012 09:12 AM
Wanted Solartex Fabric Red/White/and or Dark Blue rcgreaves Aircraft - General - Miscellaneous (FS/W) 2 Jul 03, 2012 01:31 PM
Discussion Hollow channel spars, how to fabricate? GreenAce92_v2 Composites Fabrication 2 Jun 22, 2012 12:46 AM