Homebuilt quad frame, Aeroquad 1.7 imu shield, arduino mega, and 4 props $50 OBO
this is almost a full setup, all you would need is 4 esc's 4 motors that can spin 12x3.8 props, a battery and receiver for your tx.
this is a old 1.7 IMU from aeroquad.com, the frame was built from thier instructions as well. the mega has the newest 3.1 beta firmware setup for + mode, and the frame is also alighed with + flight.
http://www.flickr.com/photos/firehop...in/photostream < everything.
http://www.flickr.com/photos/firehop...in/photostream < the mega
http://www.flickr.com/photos/firehop...in/photostream < the 1.7 flight controller.
would like 50$ O.B.O shipping would prolly be 10-20$
if my price is too high, make me a offer! I would like this stuff sold!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Wanted||WTB Arduino IMU shield for ArduPilot||gathem||FPV Equipment (FS/W)||1||Aug 16, 2011 06:18 PM|
|Sold||Complete Aeroquad Arduino Mega 2560, Shield and Sensor Kit||boolander||Aircraft - Electric - Multirotor (FS/W)||2||Jun 28, 2011 12:39 PM|
|Sold||FF IMU w/Paris AP 3.0 shield & Arduino Pro Mini 5V||fpv_copter||Aircraft - Electric - Multirotor (FS/W)||7||May 19, 2011 05:23 PM|
|Question||ArduPilotMega IMU Shield vs ArduPilot Mega board||jouse||UAV - Unmanned Aerial Vehicles||1||Nov 06, 2010 04:48 PM|