|Jul 20, 2012, 10:51 PM|
One of the nice features of this board is a jumper on the back of the board that allows the board to be configured to either 3.3V or 5V (both power output and IO level). This board ship default to 5V, but you can cut the default trace and add a solder jumper if you need to switch to 3.3V.
that is what i got from sparkfun....
|Thread||Thread Starter||Forum||Replies||Last Post|
|Sold Turnigy 9X ER9X Firmware, Backlight, Lipo, USB programming, 3 receivers||crd||Aircraft - General - Radio Equipment (FS/W)||3||Mar 11, 2012 11:09 AM|
|Sold Turnigy 9X ER9X Firmware, Backlight, Lipo, USB programming, 3 receivers||crd||FPV/RPV - Equipment and Vehicles (FS/W)||0||Mar 11, 2012 03:18 AM|
|Sold -paris 4.0 multiwii board with USB to FTDi program card. $105||imdone||Aircraft - Electric - Multirotor (FS/W)||17||Jan 17, 2012 11:14 PM|
|Discussion Can you program 3.3v cutoff using Hacker pro interface?||Brian Koester||Power Systems||0||Jul 12, 2008 06:15 PM|
|Discussion USB Programming Card?||Time Pilot||Castle Creations||1||Aug 13, 2006 08:12 AM|