|Jul 16, 2012, 10:01 PM|
My homemade mic messing up with my 9x??
So after realizing that having a mic on my fpv system would be a really nice addition, I decided to take a mic from my old headphones and wire it with help of my father. Well the sound sucked but I thought I could have an idea of my speed based on the wind. As it happened, on my flights with this setup, my 9x receiver was just below the mic. The first with I flew with this setup, I blamed my poopy flying on the wind and didn't think anything of the mic.
The signal on my fpv gear was completely fine, the transmitter is on the opposite end of the plane.
Today, I had 2 flights and both ended up in crashes.
On the first one, my elevator went crazy and my motor stopped spinning after some point. My battery was less than half full so I thought changing it would fix the issue.
Second flight was even worse, the engine was completely cut after I got 50 meters away where I was, went down but the only thing that was broken was my nose.
Another thing I noticed: After walking towards the plane, the esc was doing the beeping kind of noise that it does after there is no signal from tx. It was doing this when I was less than 20 meters away.
The question is, should I throw my mic to trash and order a decent one from ebay or somewhere or should I place it on a better position and maybe put a condenser on it? There is a lot of background noise from it.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||elevator messed up||RCAddict16||Electric Plane Talk||14||Jul 03, 2012 07:44 PM|
|Discussion||Rebuilt the head...think I may have messed up||chuck1073||Electric Heli Talk||1||Apr 17, 2012 10:13 PM|
|Discussion||Unexplicable (to me): video interference when using mic AND throttling up.||cmanley_nl||FPV Talk||5||Mar 27, 2012 08:59 AM|
|For Sale||Blade mcpx, parts and a messed up board?||billygoat11||Aircraft - Electric - Helis (FS/W)||3||Mar 21, 2012 10:14 AM|
|Discussion||My T Rex took a nose dive -- did I mess up my LiPo?||visayan||Mini Helis||2||Jul 15, 2007 11:03 PM|