Controlling Brushless Motor through ESC using Arduino - Page 2

TS00 · Jun 26, 2012, 07:45 AM

I've never had a problem controlling ESCs - I just put in a 3 second delay, and initialise them at 90 (which corresponds to zero throttle).

Skriptkid · Jun 26, 2012, 11:33 AM

Success!

Thanks a lot leprud and TS00

Couldn't have done it without your help

leprud · Jun 26, 2012, 11:36 AM

Hooray!

TS00 · Jun 26, 2012, 11:38 AM

Quote:

Originally Posted by Skriptkid

Success!

Thanks a lot leprud and TS00

Couldn't have done it without your help

Well done. It would help future generations if you could, just in a few words, describe what fixed the problem in the end.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Question How is the way to use arduino to control ESC?	windhamwong	DIY Electronics	26	Oct 17, 2012 05:29 AM
Wanted 2800kv Brushless Motor/30A Brushless ESC for Multiplex EasyStar upgrade	davidjrojas	Aircraft - Electric - Power Systems (FS/W)	1	Jun 25, 2012 12:33 PM
Help! Controlling a Brushless Motor through ESC using Arduino	Skriptkid	Beginner Training Area (Heli-Electric)	2	Jun 25, 2012 07:34 AM
Sold CC Phoenix-25 Brushless motor control (ESC)	pro bro steve	Aircraft - Electric - Power Systems (FS/W)	0	Jun 06, 2012 03:49 PM
Discussion Brushless Motor+ Speed Controller+ Arduino Uno= Problems	d4n1s	Power Systems	3	Nov 26, 2010 01:03 PM

Jun 26, 2012, 07:45 AM	#16
TS00 Ape-pilot Extraordinaire United Kingdom, England, Herefordshire Joined Jun 2011 1,493 Posts	I've never had a problem controlling ESCs - I just put in a 3 second delay, and initialise them at 90 (which corresponds to zero throttle).

Jun 26, 2012, 11:33 AM	#17
Skriptkid Registered User Joined Jun 2012 12 Posts	Success! Thanks a lot leprud and TS00 Couldn't have done it without your help

Jun 26, 2012, 11:36 AM	#18
leprud Trying to learn. Moscow, Russia Joined Jun 2010 181 Posts	Hooray!