I'm selling a brand new HET Super Sniper XL full composite jet(purchased June 1st). Got my hands on a jetcat p120 turbine, I need an airframe for it along with more room. The sniper is partially put together; ailerons and servos, rudder and servos, elevator and servos, spring air retracts, and air tanks installed. It comes with the following... - HET Super Sniper XL ARF (Paid $299) - All stock hardware - Extra added hardware;du-bro 2-56 swivel ball links and Robart swivel ball control horns (Paid around $30) - Brand new boxed HET 9504 90mm EDF(Paid $50) - Brand new boxed Typhoon 700-68-1500 brushless motor(Paid $125) - Castle Creations Phoenix Ice2 HV 120a (Paid $175)- (8) brand new Hitec HS-82MG servos all around with super strength horns(Paid $180) - Brand new never charged Hyperion life 6.6v 1475mah r/x battery(Paid $20) - Brand new HET(recommended) spring air retracts w/ all fixtures and tank(Paid $250) - Extra Robart tank(Paid $12) - Robart 100psi retract pump (paid $20)-Hard Copy manual and disk copy - Receipts for everything bought

I bought the jet, retracts, EDF, motor, and servos together at once from fanjetsusa except the ESC, additional hardware, extra Robart air Tank, and Battery. I originally had a Nano Tech 10s 4500mah 35-70c(series split pack) lipo but just tried placing in the cockpit and its a little too long(300mm length) so I will be splitting it into two packs(one 5s on top of the other) heat shrinking both packs back so the jet doesn't have to be modified. All you need is a receiver. In all I've got a little over $1300 in this project. Shipped FedEx home delivery shipping which did cost me $50 from fanjetsusa to Layton, Utah. Make an Offer.

Sold pending payment.

Sold