|May 20, 2012, 10:42 AM|
50mm FSW - EDF
Hello all, I think it's been about 7 years since I've been here on rc groups. Been busy and kinda fell out of the hobby. So this is what I am building to get back into the air. A custom eye-balled FSW with a Dons RC Wemotec/5400kv/30 amp esc/ 3cell -800mahx 2ea in parallel. Should burn a whole in the sky, I hope. A little dodgy on how to figure out the CG though, any input would be greatly appreciated, anything to help me from burying this in the dirt in 5 seconds.
|May 20, 2012, 01:54 PM|
Blue man I can calculate your CG for you if you tell me the wing span, root, and tip measurements. Also accurate sweep measurement on main wing at leading edge. I prolly have more experience with SFW than a lot of fellows the past 11 yrs alone. I'll volunteer.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||LPU in San Antonio area: 50mm JPower EDF Jets||FoamJunkE||Aircraft - Electric - Airplanes (FS/W)||2||Jun 20, 2012 06:57 AM|
|Build Log||FSW EDF 50mm||blueman||Foamy EDFs||7||May 25, 2012 03:46 AM|
|Sold||NIB 1.97 50MM EDF Housing||warbirdguyn951||Aircraft - Electric - Power Systems (FS/W)||4||May 20, 2012 10:35 AM|
|Found||Need 50mm EDF||gasturbineman||Aircraft - Electric - Jets (FS/W)||0||Mar 06, 2012 04:15 PM|
|Sold||MB-1, Wemotec 50mm, JPower 50mm edf units FS||FoamJunkE||Aircraft - Electric - Power Systems (FS/W)||0||Feb 01, 2012 09:09 AM|