|Apr 23, 2012, 08:59 PM|
With the mold ready, I pre-heated it to 200 degrees in the oven prior to doing my first pull on the vacuum form. I made two frames from MDF that sandwiched a 11x12 sheet of .020 PETG held together with a bunch of binder clips. Placing that assembly on the oven rack under the broiler, i heated it until it began to sag about 1 inch below the bottom of the frame...moved it out and quickly centered it over the mold, turned on my shopvac and...voila! Instant canopy!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Anybody use two packs for speed 400 twins?||Daniel English||Electric Plane Talk||69||Feb 26, 2014 04:49 PM|
|Discussion||NiCad Disposal||GaryK||Batteries and Chargers||28||Jan 16, 2014 01:16 PM|
|Which sensorless SC will work the best for an F7LMR and 10 cells?||GregG||Electric Plane Talk||6||Nov 18, 2013 08:21 PM|
|ARF's Cheaper Than Built-Up's Models||E-Challenged||Electric Plane Talk||42||Aug 01, 2013 10:25 AM|
|x250...not fair!!||tnsfrk||Electric Plane Talk||28||Jan 08, 2012 09:30 AM|