|Mar 16, 2012, 05:14 AM|
Custom Carbon Control Horns
More than one person has mentioned that these were not the shape they wanted.
They are fairly large blanks and I never intended for them to be used as is (though you can). I figured people would cut them to size or shape. Anyhow, if you don't have a pair of scissors and want me to cut them out to a custom shape for you the price is:
$28 for 8 delivered.
If you want to do it yourself:
(4) for $12 delivered
(8) for $20 delivered
(10) for $24 delivered
Just send payment to firstname.lastname@example.org (if you want to email me it's email@example.com)
(PM's are a pain since I have to log in and go to messages each time I get a note.)
Also, these have bump bearings on each side of the hole, so if you use a large rod instead of a wire, you will need to drill out the hole (basically removing the bumps).
Last edited by tbroeski; Mar 18, 2012 at 04:28 PM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Control Horn question||sporez||Electric Plane Talk||3||Oct 24, 2011 05:12 AM|
|Discussion||Best way to replace this expoxied control horn?||marhar||Beginner Training Area (Aircraft-Electric)||4||Sep 20, 2011 12:39 AM|
|Wanted||clevis for control horn||flyarmy58||Aircraft - General - Miscellaneous (FS/W)||6||Sep 13, 2011 03:58 PM|
|Servo horn/control horn placement||dubbs123||Parkflyers||0||Sep 16, 2005 04:34 AM|
|Servo horn/control horn placement||dubbs123||Parkflyers||0||Sep 16, 2005 03:53 AM|