|Mar 14, 2012, 07:00 PM|
San Francisco Bay Area
Joined May 2001
Unexplained interference - video attached - Any Ideas?
I have just completed a Osirus V2 foamy.
I am using a Futaba R6106HF 6-Channel 2.4GHz FASST receiver with the case removed.
I am getting intermittent interference as shown in the attached video. The interference comes and goes.. doesnít matter if Iím inside or outdoors. I can still manipulate all of the controls while the interference is occurring.
Any suggestions on what might be causing this?
|Mar 14, 2012, 07:05 PM|
Swap it around in the rx. see after swapping the elevator servo does this. If it's still the aileron then chances are its the servo itself.
|Mar 14, 2012, 08:46 PM|
Also try just disconnecting the aileron servo and do the same test again to see if the interference between channels is in the servo or not. If it still happens with the aileron servo unplugged then it's not the servo.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Help finding the source for video interference||sharonx||FPV Talk||20||Mar 21, 2012 02:39 PM|
|Discussion||Looking for an aluminum case for DJI Flame Wheel F550, any ideas?||jasper7821||Multirotor Talk||2||Mar 06, 2012 01:54 PM|
|Discussion||EMI Interference? Video Not Playing||Murocflyer||Aerial Photography||5||Feb 26, 2012 12:06 AM|
|Cool||Video cam attached to Heli Rotor blade...So what does it look like||sweatyfingers||Aerial Photography||2||Sep 18, 2011 02:05 AM|
|Help!||Gas Engine RF interference with old JR servos -- any ideas?||Illini_Rob||Engines||9||Nov 16, 2010 08:50 AM|