|Mar 03, 2012, 07:26 PM|
Problem w/ Data Transfer SD10g- help
I would like to load an emailed set up into the SD10g. Loaded the set up disk into the PC. Saved the emailed program into my documents. Opened the TX tool and picked Com port 3, chose the program file I want to use, then hit start.
new window with taskbar "Model Data Uploading" appears but nothing happens???
All the while the trans is plugged intop the pc and set up with the Data Transfer screen ready to receive. Tried to initiate with transmitter but get a Time out on the screen.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Help with DX5e w/ AR600 Problem||Meach_in_GA||Beginner Training Area (Aircraft-Electric)||7||Feb 26, 2012 09:29 PM|
|Found||JR Data Transfer JRPA310||greghol||Aircraft - General - Radio Equipment (FS/W)||1||Feb 25, 2012 07:40 AM|
|Found||JRPA310 JR PC Data Transfer||gliders||Aircraft - General - Radio Equipment (FS/W)||0||Oct 10, 2011 09:37 PM|
|Sold||JR PC Data Transfer Interface||atjurhs||Aircraft - General - Radio Equipment (FS/W)||2||Sep 19, 2011 04:19 AM|
|Discussion||JR PC Data Transfer Installation Problem||jrandle||Radios||3||Mar 31, 2010 11:01 PM|