|Mar 03, 2012, 03:47 PM|
Longer flight test
So finally, weekend is here, so I get ready my new Bixler (after gluing back aileron control horn that came loose after I hand-forced servo... aehm). It's been sunny, but windy and chilly. I made number of launches, testing various modes of flight. Relatively strong wind made it impossible to do any fine-tuning. I tried some aerobatics (loops, inverted flight). My main concern was if the wings are held together sufficiently well. Well, on about two occasions, the wings became partially unlocked, though not completely loose. At home I discovered, that one of the magnets is unglued. So I glued it back and we'll see. Maybe I will need to add more magnets, maybe I need to try something better.
Another little thing is that I use stick-on velcro to hold ESC in place. Unfortunately, the glue starts to flow when ESC gets warm/hot and the ESC gradually slides off the velcro. I used some CA glue and we'll see what happens.
As for the motor performance (Turnigy 2826 2200 KV): I haven't flown my previous plane for half a year so I cannot do a good comparison, but I would expect a little more from motor that has some 140 W of rated performance more. It's hard to evaluate the climb rate with ever present wind, but it doesn't seem to be that radically better. Sure, it's got a lot of power, but it's still not vertical climb. We'll see when I get some calmer day.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||HEXA SUPER HEAVY LIFT TESTING Video! - Maiden flight, 10lb payload test & GPS PH||wac||Multirotor Talk||23||Oct 15, 2012 08:34 PM|
|Video||itg 3205 experience , test flight||rcnoble||Electric Heli Talk||2||Mar 06, 2012 08:15 AM|
|Video||Short clip of test flight with the hk600.||SteelHeadz||Electric Heli Talk||3||Mar 02, 2012 07:03 PM|
|Discussion||my UFO... test flight. not so good, but cool!||areis81||Multirotor Talk||5||Feb 27, 2012 12:15 PM|
|Discussion||Photos, Test Flight/Test Flight, Photos?||Mode One||The Builders Workshop||15||Dec 19, 2011 11:16 AM|