Someone posted on the older thread and as I read some of the old posts on there I thought Chris was starting over again. Now realizing this is the newest thread I see he is not.

I have started working on my F-22 twin 90mm's. Once I get into it more I will post my own build thread. My specs will be:

WS 55"
Length 76"
Each edf will use it's own (4000-4500) mah 6s pack. Whatever I can fit into her.
Retracts, flaps, leading edge slats, rudders. I am contemplating not to use the leading edge slats. We will see how it goes.

Contemplating if I want to make fiberglass ducts or use a combination of hotwiring portions of the inner fuse with foam for ducts. Definately using some wood bulkheads for strength. Mixing in some foam bulkheads, I then will skin it and fiberglass the bird. Here is what I have done so far.

That is the size I have been looking for.
What plans are you using?

Originally Posted by wingspan100

That is the size I have been looking for.
What plans are you using?

My own. Used three view schematics and plotted out bulkheads every 2" inches down the fuselage. This way I could use hotwire with 2" thick foam to create fuselage parts.

Originally Posted by VIDEOPRO

My own. Used three view schematics and plotted out bulkheads every 2" inches down the fuselage. This way I could use hotwire with 2" thick foam to create fuselage parts.

I was thinking of doing something similar.

that raptor looks very nice. would be interesting to put my twin 90mm PAK FA next to it for size differences/similarities.

Subscribing. I've followed your foam builds of the F-22. Very nice work. This should be another good one.