|Jan 28, 2012, 03:09 PM|
Adding an accelerometer to a KK+ board
Following on from my big write-up of how to attach an accelerometer board to a Blackboard, here is the very simple guide on how to do it to a KK+ board
Step 1. Connect your ACC board as shown. The signal names are written on the underside of the KK+ board.
Step 2. Remove the two upper-most pot resistors (Pitch and Roll pots)
Step 3. Adjust Vref to 2.4V
The ACC board orientation is the same as in the following blog entry.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Rave||HK KK V2 Quad board (and other recent KK boards)||randall1959||Multirotor Electronics||2584||Aug 11, 2014 03:01 PM|
|For Sale||KK KR1.7 ,ESC Board and KK Frame||terriwang||Aircraft - Electric - Multirotor (FS/W)||3||Jul 26, 2011 05:22 PM|
|Discussion||interfacing accelerometer to an 8051||jayanthyk192||DIY Electronics||4||May 02, 2011 12:28 PM|