Banana Hobby Super Corsair
Hey guys. First off, I have many BH products and although most are a bit underpowered for my taste, they have all been (without exeption) very good products.
I ordered the Corsair and have now flown it 5 times. Very Very nice airplane. The only issue I had was one of the props was so far out on weight that I had to add some epoxy to the blade to get it to balance but they are now balanced and running fine.
I want to give this bird some more gitty up. I noticed the stock motor is a 250 KV setup. I have a new Turnigy C5055-400 and a 80 amp speed controller.
I know what you are thinking, why don't these dumbazz country boys just leave well enough alone and I am sure there is some merit to that but alas, I would still like to see a little more zip.
I know you have the 18 inch blade running at a lower RPM for good reason but just for giggles, do you think I can step up the volume a little without blowing up?
Here is here maiden flight.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Banana Hobby Super Corsair||Condor060||Electric Warbirds||5||Jan 26, 2012 10:33 AM|
|Wanted||Banana hobby 63" Corsair WANTED||F2G-1||Aircraft - Electric - Airplanes (FS/W)||0||Jan 25, 2012 03:53 AM|
|Yippee!||Banana Hobby F4U Corsair Maiden!||eddyraymagic||Banana Hobby||1||Dec 05, 2011 12:31 PM|
|Help!||Banana Hobby/BlitzRC Corsair F4U||eeephreakeee||Banana Hobby||9||Apr 12, 2011 10:48 AM|