New Products Flash Sale
Thread Tools
This thread is privately moderated by Graham 65, who may elect to delete unwanted replies.
Old Dec 11, 2011, 03:52 PM
Graham 65 is offline
Find More Posts by Graham 65
Registered User
Graham 65's Avatar
Chipping Norton, UK
Joined Jul 2006
399 Posts
Build Log
Bubble Dancer Electric

Top sheeted the centre section, with 3/32 sheet, its more than 4" wide so takes 2 sheets and they need to be 48" sheets, I know now!
The servo holders or at least the trays are in place as is the wiring along with a 4 pin socket for connecting when putting the wing on.
The end ribs have been bevelled to 5 degrees and the joiners are being glued in. This is out of proper order and would be easier to do in the correct order, ie when the wing is just a spar and ribs.
Graham 65 is offline Find More Posts by Graham 65
Reply With Quote
Sign up now
to remove ads between posts

Thread Tools