|Nov 03, 2011, 11:58 PM|
Eureka! 330x-s Gain Settings using Walkera WK-2801pro tx
The last time I set up my 330x-s months ago I could not figure out how to set the gain settings for the flight and hover modes on my Walkera 2801pro-tx (bound to rx-2801pro).
Thinking back it was because (a) I didn't really understand the functions of the tx, (b) it seemed not many people were using this tx on the forum for their 330x-s; those that were were using the heli mode, (c) the thread for this was soooo loooong so I did not go through every page.
Anyway, the way to do it was through the travel adjust settings (TRVADJ) and adjusting the settings for the channel that was being used.
For me I used the gear channel and found out that:
(1) The +ve side of the TRVADJ controlled the flight mode (RED LED), and
(2) The -ve side of the TRVADJ adjusts the gain for the hover mode (GREEN LED)
If the gain is too high (e.g. +100 during flight mode), the stabilization system will overcompensate with an off timing which results in a rocking motion which increases in intensity until it flips.
My settings are in the picture: +40% for flight mode and -65% for hover mode. (Btw, IMO hover mode doesn't really work).
Finally my green wire is in the rx! If it weren't for the error which caused me to set everything up again I would not have found this out
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Help with my TX settings vs Main Gain||df60532||Hoverfly Technologies||1||Oct 03, 2011 01:48 PM|
|For Sale||Walkera TX's for sale.... 1 WK-2402 and 1 WK-2603||candy76man||Aircraft - Electric - Helis (FS/W)||0||Jun 16, 2011 09:41 PM|
|Sold||WALKERA V120D05 Flybarless METAL Edition with New 3 Axis w/ WK-2801PRO||HeliPro5||Aircraft - Electric - Helis (FS/W)||0||May 24, 2011 12:45 AM|
|Sold||Walkera 4g6s + wk-2801pro RTF||misfitwrx||Aircraft - Electric - Helis (FS/W)||1||Mar 09, 2011 02:05 PM|
|Discussion||Walkera 4#3b with wk 2801 TX settings||tornadorc||Micro Helis||0||Sep 09, 2009 01:39 AM|