|Oct 23, 2011, 10:12 AM|
Tip panels are now complete but not sanded.
The plan is to start on the mid panels next.
The joiner blocks that go between the centre panel and the mids are still to be made so I will leave that unwrapped to start with.
Disc sander is on order to help with the joiner blocks.
It is a lot easier to get the right tools rather than make do with whats in the workshop for this type of build.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Bubble Dancer v Houston Hawk v Yardbird 2||Kookaburra||Thermal||20||Nov 04, 2011 02:46 AM|
|Discussion||Bubble Dancer Fuse pod too light?||cn0rris||Composites Fabrication||36||Oct 10, 2011 02:16 AM|
|Discussion||PoleCatAero EZ Bubble Dancer Build Instructions||JimMacL||Thermal||3||Sep 16, 2011 02:21 PM|