Originally Posted by RCAddict16

Haha I would rather be 40 with ten planes than 15 with 2!!!
Jetinteriorguy- did you find out if you can come to the fly-in?

Unfortunately I have to work, I have to address some last minute issues in a Cessna Citation that's supposed to leave for Brazil tomorrow. Our avionics install has been a massive headache and I can't finish the cockpit until they are finished, so I have to be there to finish when they get done. Hopefully I'll get done early enough to at least get some local flying done.

Oh ok, that stinks....... sorry....... but you are about to hit 3000 posts!

Originally Posted by RCAddict16

Haha. I don't bother with girls in high school, they are too high maintenance. Too much time to be spent on rcgroups!

Same here! I'm 17 going into my senior year, so hopefully college girls will be a more feasible prospect.

Originally Posted by 3dflyboy1

Same here! I'm 17 going into my senior year, so hopefully college girls will be a more feasible prospect.

HA, very funny. I'l be 19 on the 13t of August. I'll also be going on my second year of college (technically my fourth semester since I am taking a summer right now). If you go to a technical school, then it only gets worse.

Originally Posted by boredom.is.me

If you go to a technical school, then it only gets worse.

I'm going pre-med, so hopefully it won't be too bad.

--------------------------

Back on topic, I've been drooling over the crack pitts. It's so floaty, even compared to the slick! Too bad the power combos are already out of stock.

I heard power combos should be back in stock end of the week. A few posts back someone had mentioned it I think.

eS is waiting on reciever to show up so I can make sure all my servos work before putting them in. Sould be here tomorrow. Get quite a bit done on it tonight. Wings on, spar in , horizontal stab attached, servo arms and control arms all built. Solid be able to finish it up in no time once all the gear is tested.

Hey fellas, while we are an the subject of power systems, what other motors are people running on the 39" planes beside the one from the combo? I'm currently running a DualSky XM450ES, but it is getting a little warm with a 10x4.7 on it, so I'm thinking about swapping it out. I don't have any particular preference, I'm just curious as to what other people are using and what success they have had.

Yes, I pm'd brad an he said end of NEXT week

Hey guys! I'm now the proud owner of a Crack Pitts(without a motor... )
That's ok, I'm going to be gone this weekend anyway!

Who knows where you can get an adapter for the balance tap for Twisted Hobbys batteries when using a Thunder Power 610C charger? Thunder Power batteries cost almost twice as much!

Also...what is the max (safe) C rating the Twisted Hobbys batteries can be charged?

Originally Posted by STLAV8R

Who knows where you can get an adapter for the balance tap for Twisted Hobbys batteries when using a Thunder Power 610C charger? Thunder Power batteries cost almost twice as much!

Also...what is the max (safe) C rating the Twisted Hobbys batteries can be charged?

Hobby King has adapters to and from TPs. Here are some for 3S:

http://www.hobbyking.com/hobbyking/s...idProduct=9733

http://www.hobbyking.com/hobbyking/s...idProduct=9921

Others do, too. Here's a set for 2S through 5S:

http://www.graysonhobby.com/catalog/...thx-p-527.html

Max charging rate for TH batteries? I'm not sure about the official number, but I routinely charge them at 2C - 3C.

Dave

Originally Posted by pugsam

Hobby King has adapters to and from TPs. Here are some for 3S:

http://www.hobbyking.com/hobbyking/s...idProduct=9733

http://www.hobbyking.com/hobbyking/s...idProduct=9921

Others do, too. Here's a set for 2S through 5S:

http://www.graysonhobby.com/catalog/...thx-p-527.html

Max charging rate for TH batteries? I'm not sure about the official number, but I routinely charge them at 2C - 3C.

Dave

Thanks Dave! That is exactly the information I was looking for.

Anybody know when there are going to be some real pics of the new red SC?

ES is almost built. Just waiting on stuff to dry. All that is left is to mount control rods, esc, reciever and motor. Hoping to get it all mounted before calling it a night. Hehe.

Originally Posted by RCAddict16

Anybody know when there are going to be some real pics of the new red SC?

Not soon enough! I'm really hoping they're up before the shipping date, which is sometime next month. (not really that long of a wait, but still quite painful)

I'm waitingggg, twisted hobbys!!