Sep 15, 2011, 09:04 PM
|
|
|
|
Raptor V1 30 size ready to fly
I am selling my Thunder Tiger Raptor 30 size helicopter. This bird is complete and ready to fly, I have dialed everything in for a beginner set-up and have test flown it a few dozen times over the few days, it flies real nice and stable, however this can be set-up for 3d if you want as I have the strong OS engine in it that will fly the 3d set-up with power to spare.
Note: There is damage to the main frame where the canopy is held onto the frame from a rough landing. One of the canopy mounts is broken off.
More pictures available.
$300 takes all, or $200 without transmitter and receiver.
Includes:
Thunder Tiger Raptor complete built and test flown
OS 37SZ-H helicopter glow engine
Futaba GY401 Gyro with digital companion servo for tail rotor Futaba S9254
Hitec Eclipse 7 transmitter (Just received back from Hitec for replacement back case)
Extra set of Maverick Main wooden blades
Extra custom painted canopy (some wreckage damage, see photos)
FMA Co-Pilot flight stabilization system (NOT installed receiver went bad, needs repair)
Futaba FP-R1480F receiver channel 25
Pitch servo Futaba S3003
Throttle servo Futaba S9401
Elevator Servo Futaba S3004
Aileron Servo Futaba S3004
Receiver battery 5 cell NICAD 6 volt
Volt Watch 6 volt
Burpť extra fuel tank
After market landing skids
All documentation/instructions for transmitter and FMA C0-Pilot system
Flight training or assistance if wanted
NOTE: The FMA Co-Pilot has its own receiver built in and it doesn’t work, hence the complete flight stabilization system isn't operable, I am just throwing this in for free if someone wanted to send it in for repairs and install it back onto the helicopter. I had flown it several times with this installed the receiver just quit working the other day so I put the Futaba receiver into the helicopter.
|
|
|
|
|