Nov 17, 2012, 11:45 PM
|
|
|
United States, NV, Las Vegas
Joined Jul 2012
39 Posts
|
So I crashed my 700mm hex this afternoon on FW 5.14 during some failsafe testing. It was on the ground with the throttle stick below center. I switched to failsafe to see how it would react and it started to power down. After about three seconds, it powered back up and started to take-off. I let it go for a second to see what it was going to do and then turned off failsafe. It was too late, it took about three seconds for the computer to reset and it had started pitching hard aft. I saw the white LED and tried to recover but no luck.. It wasnt terrible but it will take a little bit of repair. Of course when I got home I started looking around and noticed that DJI updated their firmware.. Just my luck I guess..
Question: Has anyone checked the failsafe mode of FW 5.16?
Thanks,
Dietr
|
|
|
|
|