|Aug 04, 2011, 12:26 PM|
Mart, the dowel pins are a great idea, but if that does'nt work for you pm me with the dimentions and I can grind a set for you out of drill rod. I'll be at the SLOT for the next F3F race/meeting if that works. I have a surface grinder and spin jig, but I'm not always over at that shop so pm or e mail me asap.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Receiver pins||New2wingz||Beginner Training Area (Heli-Electric)||4||Jun 24, 2011 07:35 PM|
|Sold||New Trex 500 belt tail case with metal hex pins + tail drive gear + tail shaft $25||Tomy.||Aircraft - Electric - Helis (FS/W)||0||Jun 21, 2011 02:57 AM|
|Mini-HowTo||Making Bowling Pins||Tomokabear||Foamies (Scratchbuilt)||29||May 25, 2011 12:50 AM|
|Help!||1x16 pin male connector pins||sajeev||DIY Electronics||9||Apr 10, 2011 06:27 PM|
|Discussion||MPX 35Mhz RX with no Servo Pins?||air||Radios||7||Apr 03, 2011 07:55 AM|