|Jul 24, 2011, 01:31 PM|
Joined Jul 2011
FrSky V8HT on Vex Tx
I am having some issues with a project VEX transmitter upgrade to 2.4 ghz. I not sure If I have the correct PPM from the transmitter.
first I am installing FrSky V8HT 2.4Ghz DIY Module on Vex transmitter. I open up the Tx turn over the circuit board with the RJ jack & locate the signal power & ground & sober the appropriate connections. The instructions say to put the Tx in PPM mode & turn of the TX before bind. I am not sure how to do that? any one ever done this successfully ? can you tell me where to find the correct PPM signal on the VEX Tx.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||FrSky V8HT 2.4G + Hitec Neon SS||_shadow_||Radios||28||Nov 18, 2011 02:35 PM|
|Discussion||Upgrading Futaba T6XHs To 2.4 GHz With Frsky DIY V8HT Module?||FXG||DIY Electronics||14||Aug 27, 2011 05:21 PM|
|Question||Ol' Futaba Conquest PCM and FrSky V8HT Wedding||orsi bruno||Radios||16||Apr 16, 2011 07:53 PM|
|Help!||Problem with FrSky V8HT DIY module in Futaba tx||RobEm||Radios||5||Mar 31, 2011 12:21 AM|
|For Sale||FrSky V8HT 2.4Ghz DIY Module/V8FR 8ch Receiver (Hv)||wizzinbya||Aircraft - General - Radio Equipment (FS/W)||2||Mar 30, 2011 11:28 AM|