Hello,

I bought 2 Nine eagle Xtra 300 and everything was doing great. It's a nice crash proof airplane.

Few days ago I try to bind one controller on the other airplane. It work fine. And I resort the binding as it was before. But since that I have trouble with both airplane. Their Aileron are shaking when I turn on the remote.

I have try many binding, trim, reset... but nothing is fixing it. I can't fly with any of them anymore.

Do you have any idea how I can fix this problem ?

Does it happen just when you turn on the remote or all the time?

I have lots of radio gear that will do an initial glitch when switched on, but works fine during flight.

Have you tried in several different locations? It's possible that there is some source of constant interference that was not there before if you are trying this in the same place.

Hello,

First, thank you your answer. I have the problem in continus after I turn on the controller. It doesn't change anything when I turn it off. I have tried that in différents locations and I always have the same problem.

The problem is getting worst after 1-2 minutes, everything freeze. I think it's a clever safe protection to protect the engin of the ailerons of over heat.

Here is the video of the problem.

Nine eagle Xtra 300 aileron shaking probem (1 min 37 sec)

Is it possible that the servos are too accurate ? They are trying to find the best position but the engine always pushing to far in every way ?

But how come this is happening on both of my xtra 300 at the same time ? It there a way with the controller to set the accuracy ?

Does this happen with the transmitter farther away? It's possible you're "flooding" the rx with signals from the tx

The distance doesn't change anything

You have the issue on both planes and with both TXs?

I bought a new "NE4609001 771B Sky Eagle Lndividual Receiver" and it work fine now. I can't understand how I managed to break both of theme at the same time.

Thank you for your help and for your time anyway.

Hello!
Put the photo on the main board please. In a good resolution, that would be seen jack motor and MOSFET.
I'll draw the wiring diagram for a converter to connect brushless motor.



Converter can be done on a microcontroller PIC10F202
I download a free firmware

As an example - to connect to the board the helicopter Nine Eagles Solo Pro and Blade MSR

http://www.youtube.com/watch?v=BzTE4_V24b8

Wiring diagram for the converter and ESC to the board the plane



Firmware for this connection
Sorry for my English

Hi, I have the same problem. The aileron control constantly shakes off, on, away, close.

Anyone know what's going on?