Images

tallflyer · 08:55 PM

First off I want to Thanks Hobby King for giving me the chance to try this too cool little Micro Jets.

I'm doing this a a double build as they go together so fast I thought I would combine the thread into both planes.

Hobby King A-6 Information.

Specification:
Wingspan: 585mm
Length: 696mm
Flying Weight: 345g
Motor: Powerful brushless Outrunner
ESC: 20A
Servo: 3 x 9g
EDF: 50mm
Battery: 850mah 3S 11.1V 20C (Not included)

Required:
Your own Tx & RX
Battery: 850mah 3S 11.1V 20C

Hobby King F-86 Information.

Specification:
Wingspan: 645mm
Length: 640mm
Flying Weight: 370g
Motor: Powerful brushless Outrunner.
ESC: 20A
Servo: 2 x 8g
EDF: 50mm
Battery: 850mah 3S 11.1V 20C

Required:
Your own Tx & RX

Also included is a 3S lipo battery.

(note the battery for the F-86 will not fit the A-6)

Both planes can be built in less then 1 hour (I used low temp hot Glue)
the A-6 needed a 6" servo extender to reach where the receiver was located
you will need a small philps screwdriver. The esc's both have 2mm bullet connectors
on the esc side I made a jst adapter so I could use all my older packs.

I will post a picture later.

splitpilot · May 19, 2011, 11:12 PM

kuczy · May 19, 2011, 11:19 PM

I've been waiting for someone to do the A-6. If it flies well I'll be adding it to my collection.

tallflyer · May 19, 2011, 11:34 PM

I hope to get out on Sat or Sunday and take the little A-6 for the maiden!

tallflyer · Jun 04, 2011, 02:05 PM

videos are here

Flying and Crash video

Hobby King Mini F-86 EDF Fighter Jet Crash video (2 min 39 sec)

Damage and repair video

http://www.youtube.com/watch?v=Ynct7...feature=relmfu

May 19, 2011, 08:00 PM	#1
tallflyer Registered User United States, CA, San Diego Joined Jul 2002 6,054 Posts	Hobby King Micro A-6 & F-86 Jets First off I want to Thanks Hobby King for giving me the chance to try this too cool little Micro Jets. I'm doing this a a double build as they go together so fast I thought I would combine the thread into both planes. Hobby King A-6 Information. Specification: Wingspan: 585mm Length: 696mm Flying Weight: 345g Motor: Powerful brushless Outrunner ESC: 20A Servo: 3 x 9g EDF: 50mm Battery: 850mah 3S 11.1V 20C (Not included) Required: Your own Tx & RX Battery: 850mah 3S 11.1V 20C Hobby King F-86 Information. Specification: Wingspan: 645mm Length: 640mm Flying Weight: 370g Motor: Powerful brushless Outrunner. ESC: 20A Servo: 2 x 8g EDF: 50mm Battery: 850mah 3S 11.1V 20C Required: Your own Tx & RX Also included is a 3S lipo battery. (note the battery for the F-86 will not fit the A-6) Both planes can be built in less then 1 hour (I used low temp hot Glue) the A-6 needed a 6" servo extender to reach where the receiver was located you will need a small philps screwdriver. The esc's both have 2mm bullet connectors on the esc side I made a jst adapter so I could use all my older packs. I will post a picture later. Images View all Images in thread Views: 39 The A-6 Manual Views: 49 Parts Count is low these little planes go together fast. Views: 35 Aileron Servos are pre installed (notice control rod in 3rd hole from top I moved this later to get more throw. Views: 42 the other wing Views: 43 Notice Battery wires on ESC are 2mm type. Views: 41 Canopy has great detail and attached with a magnet. Views: 35 Control rod moved to top hole in horn for more throw. Views: 33 Views: 38 Wings and other surfaces are glued on with Low temp Hot Glue. Views: 37 wire for servo goes throw frame into body make sure this is done before you glue wings in place. Views: 31 Elevator is glued on using hot glue. Views: 29 then glue on the Rudder. Views: 34 Notice Servo wire for elevator is not long enough to reach front of plane where Receiver is located a 6" extender was required Views: 35 Picture of motor Views: 32 glue on the Control horns for the elevator Views: 33 Not adjustment screw is on outside to make adjusting simple. Views: 33 that all you have to do for basic build and plane is done install RC gear and you can fly in less then one hour. Views: 42 a few pictures Views: 37 more Views: 42 another Views: 37 F-86 plane builds like the A-6 Views: 29 Views: 35 Wings on the f-86 are one piece with a single servo for both Ailerons Views: 30 same type of Control horns Views: 30 elevator has location for the horns pre molded into elevator. Views: 27 Glued on with Hot glue Views: 26 Elevators installed Views: 33 Picture of control horns with rod installed Views: 31 another view Views: 28 Tail installed Views: 41 Wings installed Views: 38 Bottom foam skid installed to protect Servo
	Last edited by tallflyer; May 19, 2011 at 08:55 PM.

May 19, 2011, 11:19 PM	#3
kuczy The Earth got in the way! United States, OH, Canal Winchester Joined Feb 2007 4,880 Posts	I've been waiting for someone to do the A-6. If it flies well I'll be adding it to my collection.
	Latest blog entry: Getting into 3D a little more

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sold Ultrafly P-40's,P-51; VT F-16, F-86 wings	Hawker007	Aircraft - Electric - Airplanes (FS/W)	18	Dec 08, 2012 11:49 AM
Discussion F-86: E-Flite or Alfa?	restie	Electric Ducted Fan Jet Talk	9	May 22, 2011 09:44 PM
For Sale Fly Fly F-22 and F-86 NIB	LBJ	Aircraft - Electric - Airplanes (FS/W)	0	Apr 11, 2011 06:00 PM
Discussion F-86 Video	mike2663	Foamy EDFs	6	Mar 06, 2011 03:44 PM
Help! Venom 70 mm F-86 replace retracts?	jmscott31	Electric Ducted Fan Jet Talk	1	Mar 04, 2011 05:22 PM

Images

RCG Sites

About RCG

Features

Tools

Media

Topics

May 19, 2011, 11:12 PM	#2
splitpilot Registered User trying to catch Mr. FrSky... It flyes Joined Jan 2005 1,023 Posts

May 19, 2011, 11:34 PM	#4
tallflyer Registered User United States, CA, San Diego Joined Jul 2002 6,054 Posts	I hope to get out on Sat or Sunday and take the little A-6 for the maiden!