Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
This thread is privately moderated by cass3825, who may elect to delete unwanted replies.
Old Apr 20, 2011, 04:28 PM
cass3825 is offline
Find More Posts by cass3825
Registered User
Joined Feb 2005
507 Posts
revised Arm switch gui

fixed EEPROM read

revised sketch to not arm the motors if the copter is plugged while the tx switch is in the armed position. you must switch to disarm position then back to arm position in order to arm the motors.
cass3825 is offline Find More Posts by cass3825
Last edited by cass3825; Apr 21, 2011 at 01:00 PM. Reason: added mac gui
Reply With Quote
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion MultiWii GUI freeze troubleshooting power Multirotor Talk 16 May 08, 2011 03:14 PM
Sold S*a*l*e* #2 (REVISED) flyinjrc74 Non R/C Items (FS/W) 5 Apr 22, 2011 11:57 AM
Discussion 3 position switch instead of 2 position switch ??? vlatko DIY Electronics 3 Mar 20, 2011 07:48 AM
Sold 150mg out-put arm Actuator (Leichty) and nano-switch. arclite5 Aircraft - General - Miscellaneous (FS/W) 5 Aug 29, 2006 12:52 PM