bought a 4f200 stock setup BNF version, to use with my current walkera 2801pro tx, ive used this thread to try to get it to a *shop* setup but the rudder with not auto centre, if i move the control right, the tail moves right and stays in that position and visa versa left, i have to try and centre it myself.
this made for a maiden flight and crash combo. i am mode 2, i havent touched any of the heli gyro pot positions or anything on the heli. this cant be right as my v450d01 seems to work just fine as regards centreing, i also nbote the rudder servo has way too much travel, to the point where the servo rod trys to bend. even the operation of the swash seems awkward, not much travel on it and unequal amounts of travel say left and then right.
i am setup as per bravo47s pages (see below)
i am on the 2801 and single servo on my tx
anyone any ideas? before i get in there and start throwing a few buttons
in a trial and error way

thanks

-----------------------------------------------------------------------Originally Posted by Rafa's CB100
Hi Mick, I am missing that, and I would bet that more than just me would appreciate if you don't mind. It's just nice to have a baseline. I'm curious to see how close mine was to stock. Thanks,

Rafa

Missing docs when purchasing heli's is quite common I think. Ive found that almost every time I purchase an RC heli the seal on the box is invariably broken.

Ok heres the doc anyhow. I'll post some pics and PDF dl for those that want to print it off. Make sure you read the pages in numbered order as the first 4 pages detail 2801 mode setup and pages 5-6 are 2601 setup notes.

PDF Link- http://d01.megashares.com/dl/0a97c32/4F200setup.pdf

Picture Link- http://img409.imageshack.us/g/4f2004.jpg/

Send Rafa cb100 a pm he has a 4f200 I'm sure he can help you or try the 4F200 thread might get more help there.