|Mar 12, 2011, 04:33 PM|
mCP X settings for the Futaba 10CHP
For those who are flying or plan to fly the mCP X with a Futaba module-based tx + Spektrum module, here are the settings I'm using on my 10CHP. I also attached a Word doc. Should be a good starting point, at least. As always - use at your own risk.
I encourage those who try them to post their results and any alternate settings in this thread.
EDIT 4/17/11: When I set up the curves, was not aware that hover-pitch & hover-throttle were activated in 'normal' mode. Now that I have corrected the problem, I have updated the attachment & info below to reflect my new settings. Sorry for any confusion this may have caused.
D/R (switch D):
Note: D/R & Expo on Ch 1 & 2 only
1 Aile 90/90
2 Elev 90/90
3 Thro 100/100
4 Rudd 100/100
5 Gyro 100/100
6 Pitch 70/70
Reverse: 1 Aile, 2 Elev, 3 Thro, 4 Rudd, 6 Pitc
Idle-up: Switch E
Throttle Hold: Switch G Down
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Flight time for MCP X ?||omer921||Micro Helis||13||Feb 19, 2011 02:13 PM|
|Wanted||WANTED: Futaba 10chp working or not||tahoelight||Aircraft - General - Radio Equipment (FS/W)||1||Nov 03, 2010 12:45 AM|
|Sold||REDUCED!!FUTABA 10CHP 2.4Ghz||Alexis_Ruiz||Aircraft - General - Radio Equipment (FS/W)||13||Sep 24, 2010 01:04 AM|
|Sold||Nearly new Futaba 10CHP 2.4 Fasst AND Spektrum Module for Futaba||cryhavoc38||Aircraft - General - Radio Equipment (FS/W)||1||Jul 24, 2009 04:39 AM|