|Aug 08, 2003, 08:52 AM|
Joined Jun 2001
How do you know if the motor is still ok after a crash?
My buddy is offering me a Hacker B50 7s + 6.7:1 GB at a very good price. Say about $165. This motor have nosed in recently to medium soft ground. The fuse total and the Hacker Master FAI controller kaput as well.
He bench test the motor ok, no noise and still smooth.
I'm thinking of borrowing it for a flight before I confirm.
How else can you check?
|Aug 08, 2003, 12:00 PM|
If you have a "Whatt Meter" you can power it up to the specs and see if it matches. Any binding or such will raise the amp draw higher than the spec.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|How do you know the maximum motor current?||Propeller||Power Systems||4||Sep 21, 2004 02:57 PM|
|How do you know if you have the PolyQuest PCM Guard V1 or V2 ?||Patrick Plawner||Batteries and Chargers||3||Aug 30, 2004 02:25 PM|
|HELP! How do you know if you have a bad Rx, Tx, or antenna?||dalbert02||Radios||5||Jun 11, 2004 11:13 PM|
|How do you know when a motor is bad??||jacksonjrs||Power Systems||9||Feb 20, 2004 06:09 PM|
|How do you know if your ESC is fried?||Tres Wright||Parkflyers||3||May 16, 2002 10:19 AM|