|Jan 11, 2011, 11:49 PM|
Tconners, yes, the OSD Pro is compatible with all known stabilization systems. Normally the stabilization system connects between the OSD Pro servo outputs, and the servos themselves.
|Apr 03, 2011, 07:18 PM|
The OSD Manual states there is a potential sync issue between OSD & Co-Pilot, requiring a setting adjustment to delay one channel.
It also says to disconnect the remote channel back to the RX.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wanted Wanted: FMA CPD4 Co-Pilot or CPD4 Sensor only||Rangarid||Aircraft - General - Radio Equipment (FS/W)||2||Jan 18, 2011 03:40 PM|
|Sold FMA Co-Pilot CPD4 with Buffer for Futaba PCM Rx's||healthyfatboy||FPV/RPV - Equipment and Vehicles (FS/W)||3||Dec 16, 2010 05:12 AM|
|Wanted FMA Direct Co-Pilot II||Ed7||Aircraft - General - Radio Equipment (FS/W)||2||Nov 09, 2010 09:45 PM|
|Discussion Help with my ET OSD Pro & RangeVideo Tx harness||Cralis||Video Piloting (FPV/RPV)||122||Sep 11, 2009 10:35 AM|