Originally Posted by TheBlood+

Ok here's a pic, pretty isn't it...

BADD AZZ ! that is all i can say.

Yellow looks great-

Just waiting for my ESC to show up,then let the CHOPPING begin......Amazing work on the props Marcus

Originally Posted by VooDoo Child

Just waiting for my ESC to show up,then let the CHOPPING begin......Amazing work on the props Marcus

I hope the threads grab the nylock !!
The bolt looks slightly short ?

Originally Posted by moparmyway

I hope the threads grab the nylock !!
The bolt looks slightly short ?

I just whipped them on there finger tight,i was dying to see how it would look......All fits great.

Now that setup is going to be Bad Azz!!

Terry

Oooooo, what's the motor and prop?

VooDoo, amazing combination, should kick some butt,,,

Hi Doug

If you turn down the backside hub of the spinner ~.03",you can get it snug on the Mini-Pyro's bell, it will be less prown to vibration and look nicer.

Grtz René

Originally Posted by E-speed buff

Hi Doug

If you turn down the backside hub of the spinner ~.03",you can get it snug on the Mini-Pyro's bell, it will be less prown to vibration and look nicer.

Grtz René

.03,I am on it ....I am waiting for my other spinner to show (the one I will use for fixed props) then I will turn them down when I make my mount. Doug

I finally had some time this past weekend to get in a few flights. So far, its great. Landing are hot. But not impossible. I still need to tweak the CG. It climbs a bit. But all in all... very very nice.

The motor is not the best choice. KV is too high. Even with a 4.5x4.1 its coming down way hot. And its waaayy too loud. I think a couple of guys just about fell off their seats when I launched. I'm seriously considering a geared folder set up.

Originally Posted by mumblety-peg

I finally had some time this past weekend to get in a few flights. So far, its great. Landing are hot. But not impossible. I still need to tweak the CG. It climbs a bit. But all in all... very very nice.

The motor is not the best choice. KV is too high. Even with a 4.5x4.1 its coming down way hot. And its waaayy too loud. I think a couple of guys just about fell off their seats when I launched. I'm seriously considering a geared folder set up.

It would be nice if you could write which motor and setup you find "too hot" so me and the other dudes with limited memory capasity can get the info without searching through the whole thread to find a post where you once wrote it.
Thanks

Thanks Arcteryxxx, Sorry. I was just rambling. Not really looking for help with the motor. Mostly because I don't remember either.

Originally Posted by Arcteryxxx

It would be nice if you could write which motor and setup you find "too hot" so me and the other dudes with limited memory capasity can get the info without searching through the whole thread to find a post where you once wrote it.
Thanks

Originally Posted by mumblety-peg

Thanks Arcteryxxx, Sorry. I was just rambling. Not really looking for help with the motor. Mostly because I don't remember either.

No problem It's just that when a Dude discoveres a bad setup (e.g. excessive heat) it would be helpful to write up the components so other Dudes can learn from it. It's in this way the threads can be a common pool of knowledge for anyone to benefit from. (and for some non contributing, shady creatures to feast on too)

Originally Posted by TheBlood+

Oooooo, what's the motor and prop?

It is a XXXXXXXX XXXX-XXRO running on 7X10 Sorry,that is all i can say now ....But i will let you take a look at the insides,she is nice lookin.