Hi there everyone,

This is actually more of a 'stub' thread to let everyone know about a new product that's been developed here in RCGroups by myself with the sponsorship of other RCG patrons.

I've created for production a tiny 1x1" single cell lipo charger that'll go down as low as 10mA and up to 150mA, selectable using an easy-as-pie rotary selector (no more 4-way bit patterns to remember!)

To make it even easier I've also added a USB socket so that you can power it from pretty much anywhere. You can also power it using a 2S lipo if you use the alternative solder pads.

It'll even recover cells that have dropped a bit below 3V using a proper trickle-start charge** (recommended only if you know what you're doing!)

For the full discussion and a lot of photos - we're over at the indoor section;

Discussion thread - http://www.rcgroups.com/forums/showthread.php?t=1350540

Available at - http://nqrc.com/?vp=PLD-LICH-150