Your basic FPV Slow Stick.

20A ESC
brushless motor
mic
5A SBEC
lost model alarm
Hitec 7ch FM radio
pan and tilt
1.2ghz 800mw VTX

I am apart of the pack!

Plane: 36" Profile Foamy
RC: Futaba 9C 72mhz / RX Castle Creations Berg 4
vTX/RX: Foxtech 5.8ghz 200mw with CL/SWP
Camera: 690TVL Ultra WDR Pixim SEAWOLF 2.8mm

Foamy FPV Range Test (3 min 56 sec)

Originally Posted by GregSilver

I am apart of the pack!

Plane: 36" Profile Foamy
RC: Futaba 9C 72mhz / RX Castle Creations Berg 4
vTX/RX: Foxtech 5.8ghz 200mw with CL/SWP
Camera: 690TVL Ultra WDR Pixim SEAWOLF 2.8mm

I love this. I have flown several of my foamies FPV and I think that this is great. Nice and simple.

I tell ya that DIY patch is awesome

Originally Posted by Drednox

I tell ya that DIY patch is awesome

Nice! Have you uploaded any video?

Originally Posted by GregSilver

I am apart of the pack!

Plane: 36" Profile Foamy
RC: Futaba 9C 72mhz / RX Castle Creations Berg 4
vTX/RX: Foxtech 5.8ghz 200mw with CL/SWP
Camera: 690TVL Ultra WDR Pixim SEAWOLF 2.8mm


http://www.youtube.com/watch?v=eSzalxiWnUQ

Great video I really need to finish up my helical and SPW as my rubber dookies are getting old.

Originally Posted by Kev.au

Hope to test this bad boy out soon, just waiting on dl rx.


RCV922
RMRC 900mhz 500mw tx
RMRC LC filter
60amp ESC
ARC 28-38-2.5 Turn Brushless Inrunner Motor
Hitec HS-81 Micro Servos
APC 400 EP Prop 6 x 4E
BEVrc 180 pan servo


Cheers, Kev.

Originally Posted by Wizzard033

Still waiting on my dl rx , i did install a HK OSD, i'm just sick of looking at it hanging on the wall .


Cheers, Kev.

Originally Posted by Bear_Pants

Nice! Have you uploaded any video?

Not yet. "Maidened" the patch Sunday. Took it out to 3/4 mile with zero glitch on a HK 200 mw 900mhz TX

I need to try a Funjet sometime.

LIke the title says, this is my own design, called Easycam140, it's flown about 30 fpv flights, so it's very much tried and tested.

It flies with a 800mw HK system, with omni, and for control I am using a stock futaba 9cap on 72mhz with doubled up antenna and I am getting 3.5-4 miles solid with all omni antennas.

The osd is Remzibi with gps...

Very simple, cheap and you can count on it coming back for more...

I only had a small accident with it, but nothing serious, I went flying with a bit of drizzle and once up there it started pouring, so I got some water inside the wing, that made some of the sheer web of the wing sweel up and it's got a few spots of mold, but the wing is still solid and flying .

If I were to do it again , I'd use some WBP on the wood and spend some time doubling up covering on the endes for more water resistance.

Originally Posted by Drednox

Not yet. "Maidened" the patch Sunday. Took it out to 3/4 mile with zero glitch on a HK 200 mw 900mhz TX

Beaut.

Huge 180 cm wing with 34 cm chord... wing loading is 6 oz sq/ft.

Flight is really really slow, it can sustain height at only 15 km/h airspeed and a dribble of gas....

Hi Guys,

Did my 5th FPV flight last sunday with my Super Alula.



This is the recording of my 5th experience. I used a spy key cam for the recordings.

FPV SUPER ALULA | GETTING BETTER (7 min 54 sec)

Greetz from Holland!
Eric

Originally Posted by MarcAntonio

Huge 180 cm wing with 34 cm chord... wing loading is 6 oz sq/ft.

Flight is really really slow, it can sustain height at only 15 km/h airspeed and a dribble of gas....

Hi there,

where do you fly your bird, in Reston? I would like to watch it.
Thanks.