|Jul 16, 2003, 09:46 AM|
Joined Apr 2002
Question about battery cover...
While building a side by side AAA pack the soldering iron just glanced the plastic covering on the negative side of one of the cells causing it to melt just a bit. I'm getting a voltage from the pack, but I've yet to charge it. Should I replace the cell or does the plastic covering actually do anything.
|Jul 16, 2003, 09:51 AM|
If you are talking about a Nimh cell, no the plastic is just there as an insulator. The entire can of the cell is the negative terminal.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|question about battery capacity.||ariesmars||Batteries and Chargers||6||Sep 21, 2005 05:21 PM|
|Basic question about battery/motor matchup from a Newbie||Jimmy James||Batteries and Chargers||2||May 21, 2005 07:48 PM|
|Question about battery i.r.||skyhawk||Batteries and Chargers||1||Jun 23, 2003 12:58 PM|
|Newbie question about battery care||stu78||Batteries and Chargers||9||Jun 01, 2003 10:44 AM|
|Question about battery packs||Mike_Then||Foamies (Kits)||4||Mar 13, 2002 01:09 PM|