|Aug 19, 2010, 03:40 PM|
Over on the keyfob camera thread guys keep asking about how to mount the camera. They've come up with some ingenious methods but I think the following works pretty well for me. It started as a joke but really the vid didn't show any waviness or "jello effect" and I kind of thought the camera perpective was cool.
This trick was to find a former or bulkhead upright so you had something solid underneath the film covering. Also I put a small 1/4 inch by 1 inch piece of double sided sticky tape along the side of the keyfob to keep it from slipping. I then used some blue painters tape to make sure it stayed level (and attached to the plane) and finally I used some flyline backing wrapped to the tail as a safety lanyard (just in case).
Here's a video of the end result.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Interchangeable motor mounting (Best Practices)||coupe-r||Foamies (Scratchbuilt)||7||Jul 27, 2010 01:59 PM|
|Discussion||Video - T-Master on hard_hat & keyfob cams||Phil.Taylor||Slope||5||May 18, 2010 02:34 PM|
|Discussion||MOunting EDF units that lack the mounting lugs||byrocat||Electric Ducted Fan Jet Talk||1||Aug 25, 2009 05:54 PM|