|Jun 12, 2010, 04:48 PM|
Need Help: Gyro setup for a brushless coaxial heli
I have a coaxial heli I'm trying to make work with my DX7 Tx, two brushless motors with two brushless esc and a stand alone gyro.
TX(Rudder channel)-Futaba GY520-esc2-motor2
TX(Gear channel)-Fubata Gyro Gain connector
TX(Elevator channel)-Elevator Servo
TX(Aileron channel)-Aileron servo
I already setup the gear channel as the gyro input in the DX7 (at 50% for both positions)
After setting it up, the main motor seems to run fine but the rudder motor does not seem to respond or turn at all.
How do I setup my DX7 Tx to make it work and is this even possible?
Do I need to mix the rudder and throttle channels?
Thanks, any help is appreciated.
|Jun 13, 2010, 02:36 AM|
Joined Dec 2005
If you give it full left rudder does the second ESC arm?
Some info on the second page of this thread about the mix. http://www.rcgroups.com/forums/showthread.php?t=447808
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Need help for quadrocopter setup for autonomous flight||rp181||Multirotor Talk||6||Mar 17, 2010 09:38 PM|
|Discussion||need help with Exceed / WK g006 Gyro setup||philippets||Large Electric Helis||3||Jan 27, 2010 07:06 AM|
|Question||Gyro control without a gyro for coaxial.||atomax||Coaxial Helicopters||0||Dec 18, 2009 05:00 AM|
|Found||Trade electric setup for airplane for quality Heli Gyro||grumpy trol||Aircraft - General - Radio Equipment (FS/W)||2||Aug 29, 2009 05:10 PM|
|Wanted||Need a 3ch heli for my godson Have a good brushless setup & gyro to trade!||PilotDragonfly||Aircraft - Electric - Helis (FS/W)||2||Nov 29, 2008 11:18 PM|