|Jun 10, 2003, 02:24 AM|
Servos twitch when I start motor, why?
I am hoping someone can help me answer this question. My setup is as follows...
Flash 8 (F5B) sailplane
Hacker FAI F5F motor
Hacker Master 105amp opto controller
3 hitec servos
hitec 555 rx
When I start this the motor, then servos twitch, and it's not consistiant. about every third blip I get a twitch of the ailerons either up or down.
|Jun 10, 2003, 12:39 PM|
You probably have some low level interference then.
Twisting motor wires and putting chokes (ferrite beads) on ESC and servo wires into teh RX may reduce it belwow detectable. etc.
|Jun 10, 2003, 01:31 PM|
vintage all wires are twisted...
I must admit, that this is a new setup to me, and that it was once owned by someone else. Thanks for the input...
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Motor Start/stop -why?||Sparkorama||Electric Plane Talk||6||Mar 26, 2006 12:09 AM|
|Why do the Walkera Servos twitch? and training rig wobble||SKYWLKR||Micro Helis||5||Jul 18, 2005 06:27 AM|
|Why two caps on a motor? Why three?||Capt. Electron||Power Systems||9||Dec 09, 2004 07:33 PM|
|how do you tell when your motor's going bad||waagbuck||Parkflyers||10||Sep 23, 2002 10:21 PM|
|Nosing up when more thrust, why ?||LE PEW||Beginner Training Area (Aircraft-Electric)||8||Jun 21, 2001 11:36 AM|