|May 12, 2010, 07:41 AM|
Joined Dec 2003
Does anyone know where you can obtain blades - the aerobalsa web site indicates that the 1 1/2" X l8" blades are sold out as well as the 2" X 24" blades. I am looking for blades for a gyro schtick.
|May 12, 2010, 07:56 AM|
Yeh, I wish they had more available too. I think they must not sell enough to be worhwhile.
You could always make your own.
BTW, you might want to check your coordinate settings. I am sure that Topsham Maine is less than if not around 1000 miles from Attica Michigan.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Aerobalsa blades on Delta3 flapping head||baronrouge||Auto Gyros||16||Feb 19, 2010 03:09 PM|
|Discussion||Sources for rotorblades other than aerobalsa?||grant31781||Auto Gyros||2||Dec 02, 2009 10:11 AM|
|Discussion||New DC - Downthrust on Aerobalsa Blades||Gyroguru||Auto Gyros||6||Aug 20, 2006 06:43 PM|
|G3p0-Aerobalsa rotor blade help-Mickey||dougmontgomery||Auto Gyros||4||Nov 09, 2005 10:24 AM|
|Bolt Hole Location on Aerobalsa SG6042 blades?||Gyroguru||Auto Gyros||7||Aug 30, 2005 08:19 PM|